A CV joint lets the axle turn the wheels while the suspension moves and the wheels steer. When one wears out, it gives clear signs well before it breaks. This guide covers five signs of a bad CV joint and the simple fixes. Our drivetrain parts department lists CV joints, boots and axle parts for many vehicles.

Table of Contents
A clicking noise on turns
The classic sign is a rhythmic click or pop when you turn at low speed, often in a parking lot. The noise gets faster as the wheels turn faster. It usually points to a worn outer CV joint.
Grease thrown around the wheel
A torn boot lets the grease out and lets dirt in. Look for dark grease on the inside of the wheel or on suspension parts. A split boot is the usual start of a failed CV joint.
Vibration while accelerating
A worn inner CV joint can cause shudder when you accelerate. If the vibration eases off when you lift the throttle, have the joint and axle inspected.
A clunk when changing gears
Looseness in a worn CV joint can cause a clunk when you shift from drive to reverse or back. It is less common than clicking but points to wear in the same area.
Fixing a torn boot early
If the joint is still quiet and smooth, a new boot and fresh grease can save it. We list parts such as the Mevotech front left outer CV joint boot for the 2006 to 2009 Mazda 5. Replace boots in time, before dirt ruins the joint.
When to replace the whole axle
Once the joint clicks, an axle replacement is often easier than rebuilding the joint. Compare options in the drivetrain department and check that the years and drive type match your vehicle.
How to confirm the diagnosis
Drive in a slow circle with the window down and listen for the click, then inspect both boots. If you are not sure, contact us with your vehicle details before you order.
Outer and inner CV joint compared
A joint comes in two types on each axle. The outer the joint sits at the wheel and handles steering angle, so it clicks on turns. The inner CV joint sits near the transmission or differential and handles plunge as the suspension moves, so wear shows as vibration on acceleration. Knowing which CV joint is worn helps you decide between a boot, a joint or a whole axle.
Common CV joint mistakes
Waiting until a joint clicks loudly is the biggest mistake, because dirt has already ruined it by then. Greasing a torn boot without replacing it is another, since the joint is still open to dirt. Replacing only one side is a third error. If one joint has worn out, check the other, and check the matching boot on each side.
Price range and a checklist
the joint boots in our range start around $14, while axle assemblies cost more. Before you order a joint or boot, check the years, the side, the front or rear position and the drive type. Delivery cost and time are shown at checkout. Compare every joint option in our drivetrain parts department.
Questions people ask about a CV joint
How long can I drive with a clicking the joint? Not far, since the joint can fail and leave the wheel without drive. Is a joint the same as an axle? No, the joint is the flexible joint at the end of the axle shaft. Can a joint be repaired? Boots can be replaced if caught early, but a clicking the joint usually needs a replacement. Do I need an alignment afterwards? Often a check is sensible after axle work.
Protecting your CV joint after a repair
Check the new boot clamps are tight and that the boot is seated in its grooves. Look at the boots every time you change the oil, because a small tear grows fast. Avoid driving with the wheels at full steering lock for long periods, which stresses the outer joint. Keep an eye on grease around the wheel and under the vehicle, since it is the first sign that a boot has split again.
Step by step: confirming a bad CV joint
Park on level ground with the steering turned fully to one side. Inspect the boot on the wheel end for splits and grease. Drive slowly in a tight circle both ways and listen for clicks. Raise the front, hold the axle shaft and turn the wheel, feeling for play. Note which side clicks on which turn: a click on right turns points to the left outer joint, and the other way round for left turns. Replace the worn part, and recheck the other side.
Next step
Browse the parts mentioned in this guide, compare listings for your vehicle and check the years before you order. For more background, see fuel economy maintenance advice.